Release Notes

Parameter Description
Maximum Distance Maximum distance between a client and an AP or between a mesh point and
a mesh portal, in meters. This value is used to derive ACK and CTS timeout
times. A value of 0 specifies default settings for this parameter, where
timeouts are only modified for outdoor mesh radios which use a distance of
16km.
Spectrum Monitoring If enabled, the AP operates as a hybrid AP that can simultaneously serve
clients and monitor a single channel for spectrum analysis data.
Spectrum Monitoring Profile The spectrum monitoring profile referenced by APs using this 802.11g radio
profile. For details, see rf spectrum-profile on page 692
AM Scanning Profile The AM scanning profile referenced by APs using this 802.11g radio profile.
For details, seerf am-scan-profile on page 648
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.2 Introduced protection for 802.11b clients and support for the high-
throughput IEEE 802.11n standard
ArubaOS 3.4 Support for the following parameters:
l Spectrum load balancing
l RX Sensitivity Tuning Based Channel Reuse
l RX Sensitivity Threshold
l ARM/WIDS Override
ArubaOS 3.4.2 Support for the Beacon Regulate parameter
ArubaOS 6.0 Support for the following parameters:
l AM Scanning Profile
l Advertised regulatory max EIRP
l Spectrum Load balancing mode
l Spectrum load balancing update interval (sec)
ArubaOS 6.1 Support for the following parameters:
l Spectrum Monitoring
l Spectrum load balancing threshold (%)
ArubaOS 6.2.1.0 The Reduce Cell Size (Rx Sensitivity) parameter was introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and
master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show rf dot11g-radio-profile | 1644