Release Notes

163 | ap mesh-ht-ssid-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
ap mesh-ht-ssid-profile
ap mesh-ht-ssid-profile <profile-name>
40MHz-enableba-amsdu-enable
clone <source>
high-throughput-enable
ldpc
legacy-stations
max-rx-a-mpdu-size
max-tx-a-mpdu-size
min-mpdu-start-spacing
mpdu-agg
no
short-guard-intvl-20Mhz
short-guard-intvl-40Mhz
stbc-rx-streams
stbc-tx-streams
supported-mcs-set
temporal-diversity
Description
This command configures a mesh high-throughput SSID profile used by mesh nodes.
Syntax
Parameter Description Range Default
<profile-name>
Enter the name of an existing mesh high-
throughput SSID profile to modify that profile,
or enter a new name or create a new mesh
high-throughput profile. The mesh high-
throughput profile can have a maximum of 32
characters.
To view existing high-throughput SSID radio
profiles, use the command show ap mesh-
radio-profile.
default
40MHz-enable
Enable or disable the use of 40 MHz
channels. This parameter is enabled by
default.
enabled
ba-amsdu-enable
Enable/Disable Receive AMSDU in BA
negotiation.
disabled
clone <source>
Copy configuration information from a source
profile into the currently selected profile
high-throughput-enable
Enable or disable high-throughput (802.11n)
features
on this SSID. This parameter is enabled by
default.
enabled
ldpc
If enabled, the AP will advertise Low-density
Parity Check (LDPC) support. LDPC improves
data transmission over radio channels with
high levels of background noise.
enabled