Release Notes

show ap spectrum debug fft
show ap spectrum debug fft {ap-name <ap-name>}|{ip-addr <ip-addr>} freq-band {2.4ghz|5ghz}
avg
duty-cycle
fft-to-controller
max
normalized
raw
raw-normalized
Description
Save FFT (Fast Fourier Transform) power data to a file on the spectrum monitor.
Syntax
Parameter Description
ap-name <ap-name>
Name of the spectrum monitor for which you want to view spectrum
information.
ip-addr <ip-addr>
IP address of the spectrum monitor.
freq-band 2.4ghz|5ghz
Save information for a specific radio type, either 2.4 GHz or 5 GHz.
avg
Save FFT average information.
duty-cycle
Save FFT duty-cycle data
fft-to-controller
Save the FFT max, average and duty-cycle data
max
Save the maximum FFT power measured for all samples taken over the last
second.
normalized
Save normalized FFT information
raw
Save the raw FFT information received from driver
raw-normalized
Save FFT information received from driver and its normalized FFT
Usage Guidelines
Use this command under the guidance of your Dell technical support representative to troubleshoot FFT
power issues seen on W-AP104, W-AP105, W-AP175, W-AP130 Series, W-AP220 Series or W-AP90 series APs.
Related Commands
Command Description Mode
ap spectrum local-override
Convert an AP or AM into a
spectrum monitor by adding
it to the spectrum local-
override list.
Config mode on
master or local
controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap spectrum debug fft | 1144