Release Notes

1087 | show ap monitor debug Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Column Description
ip
The AP’s IP address.
gw-ip
IP address for the AP’s gateway.
gw-mac
MAC address for the AP’s gateway.
status
Shows if the interface is currently enabled or disabled.
pkts
Number of packets seen on the AP’s wired interface.
macs
Number of MAC addresses in the Wired MAC table for that interface.
gw-macs
Number of MAC addresses in the Wired MAC table for that interface.
tagged-pkts
Number VLAN-tagged packets sent to that interface.
vlan
The VLAN ID for the packets sent to that interface.
Packets read
Number of packets read by the AP since it was last reset.
Bytes read
Number of bytes read by the AP since it was last reset.
Num Intercepts
Number of interrupts from the AP’s driver.
Num Buffer Overflows
Number of times excessive traffic has filled the AP’s buffers.
Max PPS
Maximum throughput rate seen on the interface, in packets per second.
Cur PPS
Current throughput rate seen on the interface, in packets per second.
Max PPI
Maximum interrupt rate seen on the interface, in interrupts per second.
Cur PPI
Current interrupt rate seen on the interface, in interrupts per second.
Uptime
Number of seconds since the AP was last reset.
LMS IP
IP address of the AP’s local controller.
Master IP
IP address of the AP’s master controller.
AP type
AP model type.
Country Code
The AP’s country code. Valid radio channels for your wireless network are
based on your country code. If you change the AP’s country code, the valid
channels will be reset to the defaults for the new country.
ap
Number of other APs monitored by this AP.
sta
Number of clients and APs seen by this AP.
pap
Number of potential APs; APs which have transmitted a beacon, but have not
yet been registered.
psta
Number of potential stations; AP has seen a MAC address from the station but
hasn’t yet received traffic from it.
ch
Number of channel entries in the channel table.