Release Notes

Parameter Description
Management Frame Throttle interval
Average interval that rate limiting management frames are
sent from this radio, in seconds. If this column displays a zero
(0), rate limiting is disabled for this AP.
Management Frame Throttle Limit
Maximum number of management frames that can come
from this radio in each throttle interval.
Active Scan
Displays whether or not the active scan feature is enabled.
This option elicits more information from nearby APs, but also
creates additional management traffic on the network. Active
Scan is disabled by default, and should not be enabled except
under the direct supervision of Dell Support.
VoIP Aware Scan
Shows if VoIP aware scanning is enabled or disabled. If you
use voice handsets in the WLAN, VoIP Aware Scan should be
enabled in the ARM profile so the AP will not attempt to scan
a different channel if one of its clients has an active VoIP call.
This option requires that Scanning is also enabled.
Power Save Aware Scan
Shows if the power save aware scan is enabled or disabled. If
enabled, the AP will not scan a different channel if it has one
or more clients and is in power save mode.
Load aware Scan Threshold
The Load Aware Scan Threshold is the traffic throughput
level an AP must reach before it stops scanning. Load aware
ARM preserves network resources during periods of high
traffic by temporarily halting ARM scanning if the load for the
AP gets too high.
40 MHz intolerance
The specified setting allows ARM to determine if 40 MHz
mode of operation is allowed on the 5 GHz or 2.4 GHz
frequency band only, on both frequency bands, or on neither
frequency band.
Honor 40 MHz intolerance
Shows if 40 MHz intolerance is enabled or disabled. If
enabled, the radio will stop using the 40 MHz channels if the
40 MHz intolerance indication is received from another AP or
station.
Legacy station workaround
Shows if interoperability for misbehaving legacy stations is
enabled or disabled.
Country Code
Display the country code for the AP. The country code
specifies allowed channels for that country.
ESSID
An Extended Service Set Identifier (ESSID), for the AP.
Encryption
Encryption type used on this AP.
WPA2 Pre-Auth
802.11x settings are enabled or disabled.
DTIM Interval
Number of beacons that should elapse before an AP sends
beacon broadcasts for power save clients.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap debug received-config | 1006