Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide rf arm-profile | 461
rf arm-profile
rf
rf arm-profile <profile>
40MHz-allowed-bands {All|None|a-only|g-only}
acceptable-coverage-index <number>
active-scan (not intended for use)
assignment {disable|maintain|multi-band|single-band}
backoff-time <seconds>
client-aware
clone <profile>
error-rate-threshold <percent>
error-rate-wait-time <seconds>
free-channel-index <number>
ideal-coverage-index <number>
load-aware-scan-threshold
max-tx-power <dBm>
min-scan-time <# of scans>
min-tx-power <dBm>
mode-aware
multi-band-scan
no ...
noise-threshold <number>
noise-wait-time <seconds>
ps-aware-scan
rogue-ap-aware
scan-interval <seconds>
scan mode all-reg-domain|reg-domain
scan-time <milliseconds>
scanning
video-aware-scan
voip-aware-scan
Description
This command configures the Adaptive Radio Management (ARM) profile.
Syntax
This command includes the following configuration parameters.
Parameter Description Range Default
<profile> Name of this instance of the profile. The name must be 1-63
characters.
— “default”
40MHz-allowed- bands The specified setting allows ARM to determine if 40 MHz
mode of operation is allowed on the 5 GHz or 2.4 GHz
frequency band only, on both frequency bands, or on
neither frequency band.
All/None/
a-only/g-only
a-only
All Allows 40 MHz channels on both the 5 GHZ (802.11a) and 2.4
GHZ (802.11b/g) frequency bands.
None Disallows use of 40 MHz channels.
a-only Allows use of 40 MHz channels on the 5 GHZ (802.11a)
frequency band only.
g-only Allows use of 40 MHz channels on the 2.4 GHZ (802.11b/g)
frequency band only.