Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide apdisconnect | 145
apdisconnect
apdisconnect {ap-name <name>|bssid <bssid>|ip-addr <ipaddr>}
Description
This command disconnects a mesh point from its parent.
Syntax
Usage Guidelines
Each mesh point learns about the mesh portal from its parent (a mesh node that is part of the path to the mesh
portal). This command directs a mesh point to disassociate from its parent. The mesh point will attempt to
associate with another neighboring mesh node, if available. The old parent is not eligible for re-association for 60
seconds after disconnection.
Example
The following command disconnects a specific mesh point from its parent:
(host) (config) #apdisconnect ap-name meshpoint1
Related Commands
Command History
This command was introduced in ArubaOS 3.2
Command Information
Parameter Description
ap-name Specifies the name of the parent AP.
bssid Specifies the BSSID of the parent AP.
ip-addr Specifies the IP address of the parent AP.
Command Description Mode
apconnect This command connects a mesh point to a new specified parent. Enable or Config mode
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master controllers