Reference Guide

870 | show ipv6 datapath session table Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ipv6 datapath session table
show ipv6 datapath session table <IPv6 Address>
Description
Displays current IPv6 session on the controller.
Syntax
Example
This example displays the session access control list details.
The output of this command includes the following parameters:
Parameter Description
<IPv6 IP Address> Optional parameter. If specified, displays IPv6 datapath session table for that IP address.
By defaults, displays session table for all IPv6 addresses.
(host) #show ipv6 datapath session
Datapath Session Table Statistics
---------------------------------
Current Entries 45
High Water Mark 47
Maximum Entries 524287
Total Entries 9098
Allocation Failures 0
Duplicate Entries 0
Cross linked Entries 0
No Reverse Entries 0
Max link length 0
Datapath Session Table Entries
------------------------------
Flags: F - fast age, S - src NAT, N - dest NAT
D - deny, R - redirect, Y - no syn
H - high prio, P - set prio, T - set ToS
C - client, M - mirror, V - VOIP
I - Deep inspect, U - Locally destined
Source IP Destination IP Prot SPort DPort Cntr Prio ToS Age Destination Flags
--------- -------------- ---- ----- ----- ---- ---- --- --- ----------- -----
2003:d81f:f9f0:1001:617c:9151:6d25:f754 2003:d81f:f9f0:1001::3 58 3951 32768 0 0 0 1 tunnel 13 FYCI
2003:d81f:f9f0:1001:617c:9151:6d25:f754 2003:d81f:f9f0:1001::3 58 3950 32768 0 0 0 1 tunnel 13 FYCI
Parameter Description
Source IP The source IP address of the datapath.
Destination IP The destination IP address of the datapath.
Prot Denotes the protocol number.
SPort Source port of the datapath.
DPort Destination port of the datapath.
ToS Specifies the type of service.