Reference Guide
385 |remote-node-profile Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Syntax
Parameter Description
aaa Configure authentication server using an internal server. For details, see
“aaa authentication-server internal” on page39
cellular profile <name> Cellular interface profile associated with this Remote Node profile. For
details, see “cellular profile” on page144.
clone <profile-name> Use this command to copy a Remote Node profile to this profile.
controller-ip loopback Configure the controller IP. For details on using this command, see
“controller-ip” on page158.
controller-ip vlan <id> ip address Select one of the following parameters for the VLAN interface
dhcp-client: The remote node will use DHCP to obtain IP address
internal: Then remote node IP will be derived from the remote node
DHCP pool.
pppoe: Use PPPoE to obtain IP address
dialer group <name> Dialer group profile associated with this Remote Node profile.
instance Configure the Remote Node MAC address to associate the Remote Node
to this profile. When you create a new Remote Node profile, enter the
remote-node profile instance command first.
interface Configure the Remote Node interface
z cellular—Configure the cellular Interface.
z fastethernet—Configure the FastEthernet (IEEE 802.3) interface.
z gigabitethernet—Configure the GigabitEthernet Interface.
z loopback—Configure the Loopback Interface.
z port-channel—Configure the Ethernet channel of interfaces.
z tunnel—Configure the Tunnel interface.
z vlan —Configure the Switch VLAN Virtual Interface.
NOTE: The VLAN ID mapped using the “interface vlan <id> ip address”
command can use the following parameters to define how the controller-
ip is derived:
dhcp-client: The remote node will use DHCP to obtain
IP address
internal: Then remote node IP will be derived from the
remote node DHCP pool.
pppoe: Use PPPoE to obtain IP address
For details on using this command, see “interface fastethernet |
gigabitethernet” on page247
ip Configure the Interface Internet Protocol configuration commands
z default-gateway
z domain
z domain-name
z name-server
z radius
z route