Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide uplink | 1156
uplink
crypto-local
uplink {cellular priority <prior>}|disable|enable|{wired priority <prior>}|{wired
vlan <id>}
Description
Manage and configure the uplink network connection on the Aruba 600 controllers.
Syntax
Usage Guidelines
The Aruba 600 controllers supports multiple 3G cellular uplinks in addition to its standard wired ports, providing
redundancy in the event of a connection failure. If an Aruba 600’s wired link cannot access the internet, the
controller can fail over to a secondary cellular link and continue routing traffic.
Command History
Command Information
Parameter Description Range
cellular priority <prior> Set the priority of the cellular uplink. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary
link and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired link
priority will set your cellular link as the primary controller link.
1-255
enable Enable the uplink manager.
—
disable Disable the uplink manager. —
wired priority <prior> Set the priority of the wired uplink. Each uplink type has an associated
priority; wired ports having the highest priority by default.
1-255
wired vlan <id> Define the VLAN identification (ID) of the uplink VLAN . A maxmim of
four wired VLANs can be defined
1-4094
Release Modification
ArubaOS 3.4 Command introduced
ArubaOS 6.0 The wired prority parameter was introduced.
Platforms Licensing Command Mode
Aruba 600 controllers Base operating system Config mode on master and local controllers