Reference Guide

1136 |snmp-server Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Syntax
Usage Guidelines
This command configures SNMP on the controller only. You configure SNMP-related information for APs in an
SNMP profile which you apply to an AP group or to a specific AP. To configure SNMP hostname, contact, and
location information for the controller, use the hostname, syscontact, and syslocation commands.
Example
The following command configures an SNMP trap receiver:
(host) (config) #snmp-server host 191.168.1.1 version 2c 12345678
Parameter Description Range Default
community
Sets the read-only community string. — —
enable trap
Enables sending of SNMP traps to the configured host. — disabled
engine-id
Sets the SNMP server engine ID as a hexadecimal number. 24 characters
maximum
—
host
Configures the IP address of the host to which SNMP traps are sent. This
host needs to be running a trap receiver to receive and interpret the
traps sent by the controller.
——
version
Configures the SNMP version and security string for notification
messages.
——
inform
Sends SNMP inform messages to the configured host. — disabled
inform
Specifies the length for the SNMP inform queue. 100-350 250
stats
Allows file-based statistics collection for Mobility Manager. The
controller generates a file that contains statistics data used by Mobility
Manager to display information in chart and graph formats.
File-based statistics collection is transparent to the user and increases
the efficiency of transferring information between the controller and
Mobility Manager.
enabled
trap
Source IP address of SNMP traps. — disabled
disable
Disables an SNMP trap. You can get a list of valid trap names using the
show snmp trap-list command.
——
enable
Enables an SNMP trap. — —
source
Enter the source IP address for sending traps. — —
interval
Estimated round trip time to this host. 60 seconds
retrycount
Number of times that SNMP inform messages are attempted to be sent to
the host before giving up.
3
udp-port
The port number to which notification messages are sent. — 162
user
Configures an SNMPv3 user profile for the specified username. — —
auth-prot
Authentication protocol for the user, either HMAC-MD5-98 Digest
Authentication Protocol (MD5) or HMAC-SHA-98 Digest Authentication
Protocol (SHA), and the password for use with the designated protocol.
MD5/SHA SHA
priv-prot
Privacy protocol for the user, either Advanced Encryption Standard (AES)
or CBC-DES Symmetric Encryption Protocol (DES), and the password for
use with the designated protocol.
AES/DES DES