Release Notes

Parameter Description
define how the controller-ip is derived:
n dhcp-client: The remote node will use DHCP to obtain
IP address
n internal: Then remote node IP will be derived from the
remote node DHCP pool.
n pppoe: Use PPPoE to obtain IP address
For details on using this command,
see interface fastethernet | gigabitethernet on page 405
ip
Configure the Interface Internet Protocol configuration sub
commands. For details, see command descriptions beginning
with ip default-gateway on page 445.
l default-gateway
l domain lookup
l domain-name
l name-server
l nat
l radius
l route
ipv6
Configure the Global IPv6 configuration sub commands. For
details, see command descriptions beginning with ipv6
enable on page 486.
l enable
l route X:X:X:X::X/<0-128>
logging
Set the logging level up to which messages are logged.
l A.B.C.D
l facility
l level
For details on using this command, see logging on page 541
mgmt-server
Register Mgmt Server IP Address with the controller.This
could be AirWave Management Server or any other server
that would like to receive messages from the controller using
AMON protocol. For details on using this command, see
mgmt-server type on page 560.
mgmt-user
Configure a management user. For details on using this
command, see mgmt-user on page 561.
mobility-manager
Configure a mobility manager. For details on using
command, see mobility-manager on page 564.
model <model_type>
Controller model associated to the Remote Node profile,
where <model-type> is one of the following controller model
types:
l W-3200
l W-3400
l W-3600
l W-620
l W-650
no
Delete a remote node profile.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide remote-node-profile (deprecated) | 642