Release Notes

2083 | wlan tsm-req-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
no
Negates any configured parameter — —
num-repeats <num-repeats>
This parameter is used to set the
"Number of Repetitions" field in the
Transmit Stream/Category
Measurement Request frame. The
Number of Repetitions field contains
the requested number of repetitions
for all the Measurement Request
elements in this frame. A value of zero
in the Number of Repetitions field
indicates Measurement Request
elements are executed once without
repetition. A value of 65535 in the
Number of Repetitions field indicates
Measurement Request elements are
repeated until the measurement is
cancelled or superseded.
0-65535 65535
random-interval <random-interval>
This parameter is used to set the
Randomization Interval field in the
Transmit Stream/Category
Measurement Request frame. The
Randomization Interval is used to
specify the desired maximum random
delay in the measurement start time.
It is expressed in units of TUs (Time
Units). When the request mode for the
Transmit Stream/Category
Measurement Request frame is set to
"triggered", the Randomization
Interval is not used and is set to 0. A
Randomization Interval of 0 in a
measurement request indicates that
no random delay is to be used.
0-65535 0
request-mode {normal | triggered}
This parameter is used to determine
the request mode for the Transmit
Stream/Category Measurement
Request frame. There are two options
for this field:
l normal
l triggered
—
normal
traffic-id <traffic-id>
The parameter is used to set the
Traffic Identifier field in the Transmit
Stream/Category Measurement
Request frame. The Traffic Identifier
field contains the TID subfield. The TID
subfield indicates the TC or TS for
which traffic is to be measured.
0-255 96
Usage Guidelines
The tsm-req-profile is a part of the 802.11K profile. It is used to configure the parameters for the Transmit
Stream/Category Measurement frames. It takes effect only when the 802.11K feature is enabled.
Example
(host) (config) # wlan tsm-req-profile default
(host) (TSM Report Request Profile "default") #bin0-range 1