Release Notes

10 | The ArubaOS Command-Line Interface Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Command Description
l heartbeat:
l heartbeat-interval
l heartbeat-threshold
l over-subscription
l pre-shared-key
l state-sync
interface fastethernet |
gigabitethernet
The lldp parameter is introduced.
interface vlan The dhcp parameter for configuring dynamic host configuration
protocol for IPv6 is introduced.
interface tunnel Tunnel destination ipv6, tunnel mode gre ipv6, tunnel source ipv6,
parameters are introduced.
ip access-list session The redirect parameter is introduced under action. The app, and
appcategory parameters are introduced under service.
ip igmp The ssm-range parameter is introduced.
ipv6 mld The ssm-range parameter is introduced.
ipv6 route The vlan parameter is introduced.
ntp server The IPv6 parameter is introduced.
show aaa authentication-server
radius
The called-station-id parameter is added to the output of this
command.
show airgroup The dlna and mdns parameters were introduced in the following
commands:
l show airgroup blocked-queries
l show airgroup blocked-service-id
l show airgroup internal-state statistics
The dlna, mdns , and verbose parameters were introduced in the
following commands:
l show airgroupservice
l show airgroup servers
l show airgroup users
The dlna, mdns , and static parameters were introduced in the
following command:
l show airgroup cache entries
show airgroupservice The dlna, mdns, and verbose parameters were introduced.
show app lync traffic-control The profile-name parameter is introduced.
show datapath The following parameters are introduced:
l dpi
l session dpi
l session ipv6 dpi
l session session-id dpi
show ipv6 interface The tunnel parameter is introduced in the output.