Users Guide

782 | Behavior and Defaults Dell PowerConnect W-Series ArubaOS 6.1 | User Guide
network-operations
(continued)
Monitoring > Network > All Access Points
Monitoring > Network > All Wired Access Points
You can view the reports created by the following CLI commands:
 DB:opcode=monitor-summary
 DB:opcode=cr-load
 DB:opcode=wlm-search&class=probes&start
 DB:opcode=wlm-search&class=amii
 DB:opcode=monitor-get-all-gps&status=any
 show ap-group
 show vlan status
Monitoring > Controller > Controller Summary
You can view the reports created by the following CLI commands:
 show switches
 show switches summary
Monitoring > Controller > Air Monitors
You can view the reports created by the following CLI commands:
 show wlan-ap start
*
Monitoring > Controller > Clients
You can view the reports created by the following CLI commands:
 show ip mobile host
 show ip mobile trail {<ipaddr> | <macaddr>}
 show esi groups
 show esi servers
 show esi ping
 show esi parser stats
 show private port status
*
 show vlan
 show port stats
 show spanning-tree interface fastethernet <slot/port>
 show interface fastethernet <slot/port> counters
 clear counters fastethernet <slot/port>
 show snmp trap-queue <page>
Monitoring > Controller > Clients > Packet Capture
Monitoring > Controller > Clients > Locate
Monitoring > Controller > Clients > Debug
You can view the reports created by the following CLI commands:
 aaa user debug mac
Monitoring > Controller > Clients > Disconnect
You can view the reports created by the following CLI commands:
 stm kick-off-sta <macaddr>
 aaa user logout <ipaddr>
Table 173 Predefined Management Roles (Continued)
Predefined Role Permissions