Reference Guide

823 | show interface gigabitethernet Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show interface gigabitethernet
show interface gigabitethernet <slot/port>
Description
Displays information about a specified Gigabit ethernet port.
Syntax
Examples
The example below shows the output of show interface gigabitethernet 1/0.
The output of this command includes the following parameters:
Parameter Description
counters Displays L2 interface counters for the specified interface.
switchport Displays L2 interface information.
untrusted-vlan Displays port member vlan untrusted status.
xsec Displays xsec configuration.
Parameter Description
GE 1/0 is... Displays the status of the specified port.
line protocol is... Displays the status of the line protocol on the specified port.
Hardware is.... Describes the hardware interface type.
address is... Displays the MAC address of the hardware interface.
Description The port type, name, and connector type.
Encapsulation Encapsulation method assigned to this port.
loopback... Displays whether or not loopback is set.
Configured Configured transfer operation and speed.
Negotiated Negotiated transfer operation and speed.
MTU bytes MTU size of the specified port in bytes.
#show interface gigabitethernet 1/0
GE 1/0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 00:0B:86:F0:33:E1 (bia 00:0B:86:F0:33:E1)
Description: GE1/0 (RJ45 Connector)
Encapsulation ARPA, loopback not set
Configured: Duplex ( AUTO ), speed ( AUTO )
Negotiated: Duplex (Full), speed (100 Mbps)
MTU 1500 bytes, BW is 100 Mbit
Last clearing of "show interface" counters 23 day 4 hr 27 min 54 sec
link status last changed 15 day 3 hr 15 min 21 sec
2049219 packets input, 112651020 bytes
Received 911909 broadcasts, 0 runts, 0 giants, 0 throttles
26 input error bytes, 0 CRC, 0 frame
906926 multicast, 1137310 unicast
185897 packets output, 58327172 bytes