Reference Guide

110 | ap system-profile Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
maintenance-
mode
Enable or disable AP maintenance mode.
This setting is useful when deploying, maintaining, or
upgrading the network.
If enabled, APs stop flooding unnecessary traps and syslog
messages to network management systems or network
operations centers when deploying, maintaining, or
upgrading the network. The controller still generates debug
syslog messages if debug logging is enabled.
disabled
master-ip In multi-controller networks, specifies the IP address of the
master controller. This address must be reachable by the
APs.
——
max-request-re
tries
Maximum number of times to retry AP-generated requests,
including keepalive messages. After the maximum number
of retries, the AP either tries the IP address specified by the
bkup-lms-ip (if configured) or reboots.
1-65535 10
mtu MTU, in bytes, on the wired link for the AP. 1024-1578 —
native-vlan-id Native VLAN for bridge mode virtual APs (frames on the
native VLAN are not tagged with 802.1q tags).
—1
no Negates any configured parameter. — —
ortronics-high-temp
<ortronics-high-
temp>
Temperature (in degrees Celsius) at which to decrease
transmit power on Ortronics APs.
110 C
ortronics-led-to Enable or disable the LED off timeout feature for
Ortronics APs.
Enabled
ortronics-low-temp
<ortronics-low-
temp>
Temperature (in degrees Celsius) at which to restore
configured power on Ortronics APs.
100 C
ortronics-walljack Enable or disable the wall jack on Ortronics DuoWJ
APs
Enabled
rap-bw-total This is the total reserved uplink bandwidth (in Kilobits per
second).
rap-bw-resv-1 Session ACLs with uplink bandwidth reservation in kilobits
per second. You can specify upto three session ACLs to
reserve uplink bandwidth. The sum of the three uplink
bandwidths should not exceed the rap-bw-total value.
rap-bw-resv-2
rap-bw-resv-3
rap-dhcp-
default-router
IP address for the default DHCP router. 192.168.11.1
rap-dhcp-dns-
server
IP address of the DNS server. 192.168.11.1
rap-dhcp-lease The amount of days that the assigned IP address is valid for
the client. Specify the lease in <days>.
0 indicates the IP address is always valid; the lease does
not expire.
0-30 0
rap-dhcp-pool-
end
Configures a DHCP pool for remote APs. This is the last IP
address of the DHCP pool.
192.168.11.254
rap-dhcp-pool-
netmask
Configures a DHCP pool for remote APs. This is the netmask
used for the DHCP pool.
255.255.255.0
rap-dhcp-pool-
start
Configures a DHCP pool for remote APs. This is the first IP
address of the DHCP pool.
192.168.11.2
Parameter Description Range Default