Deployment Guide

21
Dell EMC Networking - Deploying VMware vSAN with OS10 Enterprise Edition | version 1.0
9. On the Manage VMkernel network adapters page, each host is listed with its VMkernel adapters
beneath it. Only the default ESXi management VMkernel will be present.
a. Select the ESXi management VMkernel adapter, vmk0, on the first host and click
b. Choose the management port group (example: Management-vds01-vSAN). Click OK.
c. Repeat steps 9.a. - 9.b. for each of the remaining hosts in the vSAN cluster.
Manage VMkernel network adapters, step 7a-b
d. Click on the first host, then click on
i. On the Select target device page, click on the Browse button for Select an existing network.
ii. Choose the vMotion port group (example: vMotion-vds01-vSAN). Click OK > Next.
iii. On the Port properties page, for Enabled services, check the vMotion checkbox. Leave all
other settings as default. Click Next.
iv. On the IPv4 settings page, if DHCP is not used, select Use static IPv4 settings. Set the I
P
ad
dress (example: 172.20.31.101, 255.255.255.0, gw 172.20.31.253) and subnet mask for th
e
hos
t on the vMotion network. Click Next > Finish.
v. Repeat step 9.d for each of the remaining hosts in the vSAN cluster.
e. Click on the first host, then click
on
i. O
n the Select target device page, click on the Browse button for Select an existing network.
ii. Choose the vSAN port group (example: vSAN-vds01-vSAN). Click OK > Next.
iii. On the Port properties page, for Enabled services, check the vSAN checkbox. Leave all other
settings as default. Click Next.
iv. On the IPv4 settings page, if DHCP is not used, select Use static IPv4 settings. Set the I
P
ad
dress (example: 172.20.32.101, 255.255.255.0, gw 172.20.32.253) and subnet mask for th
e
hos
t on the vSAN network. Click Next > Finish.