Users Guide
Table Of Contents
- VMware vSphere ESXi 6.5.x on Dell EMC PowerEdge Systems Installation Instructions and Important Information Guide
- Introduction
- Installing vSphere 6.5.x
- Download Dell EMC customized ESXi image
- Installing, enabling and disabling ESXi
- Overview of Dell NUMA Fault Resilient Memory
- Enabling Dell NUMA Fault Resilient Memory
- Overview of Dell Fault Resilient Memory
- Enabling Dell Fault Resilient Memory
- Installing ESXi on flash media
- Installing ESXi on the hard drive
- Installing ESXi on the BOSS-S1 device
- Enabling or disabling internal SD card
- Configuring one-time boot to ESXi
- Configuring boot sequence to ESXi
- VMware ESXi Secure boot support for Dell EMC PowerEdge Servers
- Downloading patches and updates for ESXi
- Creating vCenter Server installation media
- Installing vCenter Server
- Deploying vSphere 6.5.x
- Configuration back up and restore procedures
- Licensing information
- Troubleshooting ESXi
- Getting help
Figure 8. Target devices not displayed
Why does ESXi display the number of processors incorrectly
Cause:
This issue occurs if the Snoop mode option is set to Cluster on Die in the BIOS Memory Settings screen of a dual processor
system.
Resolution:
To display the accurate number of processors, ensure that the Snoop mode option is not set to Cluster on Die in the BIOS
Memory Settings screen.
26
Troubleshooting ESXi