Deployment Guide

Installation and Upgrade 29
Installation and Setup
The vFoglight VMware Connector configuration screen appears.
Figure 2
To configure the vFoglight VMware Connector:
1 In the vFoglight VMware Connector configuration screen, enter the agent name
as you want it to be displayed in vFoglight.
Note If you have more that one agent collecting, make sure each agent name is unique.
2 Enter the vFoglight Server name or IP Address.
3 Enter the port number of the port that the vFoglight Server uses for HTTP traffic.
The default is 8080.
4 If this port requires SSL, check the SSL check box.
5 Enter a Sample Interval time in seconds. The sample interval determines how
often data is sent to vFoglight.
The default value is 120 seconds. If you enter a lower interval, you could
encounter performance problems while gaining little or nothing in terms of the
quality of your data. If you enter a number that is too high, you may not receive
data often enough for it to be of much value.
6 Click Save to have your entries validated.