Deployment Guide

26 Cartridge for VMware
Installation Guide
If the installation is successful, the message Cartridge has been installed
successfully appears in the Install Cartridge area and Virtual-VMware is listed in
the Cartridge Inventory table.
If Enable on install was not selected (see step 5 above), a caution symbol
appears in the Virtual-VMware row in the Cartridge Inventory table.
Enabling the VMware Cartridge
Enabling a cartridge completes the process of adding it to vFoglight and makes its
components available for use.
The following procedure should be performed only if you did not enable your cartridge
during the installation process, as outlined in step 5 of the Installing the VMware
Cartridge procedure.
To enable the cartridge:
1 In the navigation panel of vFoglight, navigate to Dashboards > Administration
> Cartridges > Cartridge Inventory.
2 Click Cartridge Inventory.
The Cartridge Inventory page appears in the display panel.
3 In the Cartridge Inventory table, click the row that corresponds to the VMware
Cartridge.
The row becomes highlighted.
4 Click the Enable Selected button at the bottom of the page.
The Cartridge Confirmation dialog appears.
5 To enable the cartridge, click OK.
When the cartridge is enabled successfully, a success message appears below the
Cartridge Inventory table and an Enabled status icon appears in the Virtual-VMware
row.