Reference Guide

vConverter v4.1 Chapter 5 Using vConverter CLI 166
Options Required Description
Output to
Windows
shared
folders
Output
to ESX
Server
/vm
vpc|
vmware|
legacyvmware|
virtualiron|
vmwareesx
+ +
Specifies target VM:
• vpc—Virtual PC (vhd file)
• vmware—VMware Workstation 4.x
and higher, and Server (vdmk file)
• legacyvmware—older version of
VMware Workstation
• virtualiron—Virtual Iron
• vmwareesx—Vmware ESX
Server 3.x
/split
- -
Turns on image files splitting.
For VMware:
• maximum file size is set to 2Gb
• produced file type is either
twoGbMaxExtentSparse or
twoGbMaxExtentFlat [Error!
Reference source not found.]
For Virtual PC:
• maximum file size is set to 4Gb
• produced file type is either Dynamic
Hard Disk Image (Split) or
FixedHard Disk Image (Split)
[Error! Reference source not
found.]
/flat
- -
Forces tool to allocate all space for the image
at time of creation. In this case, image size
will match disk size roughly. If not specified,
a sparse image is created (monolithicSparse,
twoGbMaxExtentSparse, Dynamic Hard
Disk Image, Dynamic Hard Disk Image
(Split)).
/adapter ide|bus|lsi|adaptec
+ +
Defines disk adapter type (* this value is
applied for both capturing and migration
steps).
For VMware, valid values are: