Reference Guide

vConverter v4.1 Chapter 4 Using vConverter 148
88BCreate and Run Conversion Job (Using the Wizard)
If you have already defined task and user profiles, you can use them in combination with
the Conversion Wizard to produce conversion jobs.
A few things to address before you begin:
• Confirm that the DNS servers have been set through Control Panel→Network
Connections.
• If you intend to resize any volumes during this process, confirm that the Create
Flat Disk Image option has been enabled through Tools→Preferences→Task
Properties. On the Wizard’s Step 4 dialog, you can confirm that this setting has
been saved.
• If you are converting multiple volumes and want each to be stored as a separate
image file, confirm that the Create Separate File for Each Volume option is
enabled through Tools→Preferences→Task Properties.
• If you want vConverter to skip certain sectors on your hard drive, confirm that the
Skip Bad Sectors where Possible setting is enabled through
Tools→Preferences→Task Properties.
1. In the Toolbar, click the Run Conversion Wizard icon.
2. Click Close.
3. Click Next.