Reference Guide

vConverter v4.1 Chapter 4 Using vConverter 140
4. Drag the source to the source server hotspot on the Conversion Tasks pane. Enter
administrator credentials for the source. Select the Save as a new user profile
checkbox. Click OK.
5. When you are prompted to save the user profile, populate the Name field and
click OK.
6. Set the volume to be converted by selecting the appropriate checkbox below the
source server hotspot. Then, select a value from the Virtual Machine type
dropdown.
7. Select a Transfer Mode—Block-Based or File-Based.
8. Select Single Conversion from the Conversion Type dropdown.
A Run At dropdown and spinbox display.
9. Select a date and time, respectively, from the dropdown and spinbox.
10. Select a value from the Target dropdown.
11. In the Target Folder field, select a location for storing the new disk and
configuration files.
Note: If you select a folder that begins or ends with a whitespace, an error
message will display.
12. If you want to base this job on an existing task profile, select it from the Use
Profile for Conversion dropdown. Click Apply.