Reference Guide

vConverter v4.1 Chapter 4 Using vConverter 104
Synchronization
At
Destinations Cutover, this field indicates the date and time of
initial synchronization.
Synchronization
Interval
For Synchronized Cutover, Continuous Protection, and Different
Destinations Cutover, this field indicates the number of times
within a particular timeframe (hours….) that synchronization will
occur.
Final
Synchronization
At
For Synchronized Cutover, this field indicates the date and time of
final synchronization.
Current Activity This dropdown displays when you select Different Destinations
Cutover as the conversion type. The values in this field include:
• Initial Conversion—active
• Changing Destination—paused
• Final Synchronization—active
Target Destination of conversion. This field is populated based on the
value that you select in the Virtual Machine type field. If you
select conversion to ESX Server or Xen, this is a network shared
folder or explicit server address.
Target Folder Location of the VM on the target server. If you do not specify a
folder value during job configuration, the VMDK file location
defaults to the same location as the VM configuration files in the
Target Folder field.
Note: If you select a folder that begins or ends with a whitespace,
an error message will display.
Use Profile for
Conversion
Populates with data based on profiles created earlier. Default is
(none). After you select a profile from the dropdown, the Apply
button adjacent to the field becomes enabled. It remains disabled if
the value is (none).
Advanced Opens the Advanced Properties window, which features general
information about altering the virtual disk type and Hardware
Abstraction Layer (HAL) type. When you close that window, the
Advanced Properties dialog displays with several tabs—Disks,
VM, Migration, and Login. For additional information the fields
on these tabs, see the Advanced Properties section in this chapter.
Cutover Now This button displays when you select Synchronized Cutover as the
conversion type.
There are several buttons and icons on the Conversion Tasks pane.