Reference Guide

vConverter v4.1 Chapter 4 Using vConverter 102
To enable the fields in the Conversion Tasks pane, click the Edit icon. Just above
the area where you define basic properties, there is a group of columns within the Source
Drives field.
Volume Identifies source volume and location. Select a checkbox for the
volume you want to use in a conversion.
Note: You must assign a drive letter. Otherwise, the disk will not
display in the Volume field.
File System Identifies file system type.
Size, GB Identifies size of volume.
Free, GB Indicates disk space free on the target.
Resize GB Use the arrows in this field to enter a new size for a volume. You
cannot make a partition smaller than the amount of data used in
the volume.
Notes: To secure an accurate value, you must make the change
using the arrows. To decrease the size of a volume, you must
enable the Create flat disk image option through Task Profile
Properties→Disks. You can confirm that it is enabled on the
Advanced Properties dialog.
Folder Identifies the folder name for the target.