Deployment Guide
Installing and Running the vFoglight Agent Manager (FglAM) 99
Installing the vFoglight Agent Manager
To install the vFoglight Agent Manager from the command line:
1
Launch a command window on the target machine and navigate to the directory
to which you downloaded the installer.
2
Run the installer executable by specifying the following:
fglam-windows-[ia32|x64].exe --headless
Messages appear in the command window while the installer starts and installer
files are being extracted to a temporary location on your machine.
The Introduction step appears in the command window when the installer has
finished loading.
3
Review the information in the Introduction and press
Enter
to move to the next
step.
The first part of the License Agreement step appears.
4
Press Enter to cause subsequent portions of the license agreement to appear.
5
At the prompt, type
Y
and press
Enter
to accept the terms of the license agreement.
Note You need to accept the license agreement before you can install the product.
The Installation Directory step appears.
6
At the
Install directory
prompt, type the path to the directory where you want to
install the vFoglight Agent Manager and press
Enter
or simply press
Enter
to
accept the default installation directory.
Note If the specified directory does not exist, the installer prompts you regarding whether
or not you would like it to be created. To create a directory, press
Enter
. To return to
the
Install directory
prompt, type
N
and then press
Enter
.
The Configure vFMS URLs step appears.
7
The Configure vFMS URLs step and its sub-steps allow you to configure multiple
ways of connecting the vFoglight Agent Manager to the vFoglight Management
Server.
For example, you can specify a single URL or configure multiple Management
Server URLs for failover purposes.
Note You can also configure Management Server URLs at a later time using the vFoglight
Agent Manager configuration interface. See “Configuring the vFoglight Agent
Manager” on page 104 for information about launching this interface post-
installation.
8
Type
4
and press
Enter
to select the
Add a new URL
option.