Deployment Guide

Installing vFoglight 65
Installing a New Version of the vFoglight Management Server
Installation Modes
Although the installer follows the same general steps on all platforms (license
agreement, shortcut creation), additional steps may be required for some platforms.
The default mode for the installer is the graphical user interface mode. However, the
vFoglight installer can be started in command-line mode in cases where a graphics
display is not available by using the silent mode.
Silent Mode
In silent mode, a properties file is used to feed in the properties. The file consists of a list
of key-value pairs, which are described in the table below. To execute the silent mode:
Windows
vFoglight-5_2_4-install_windows-ia32.exe -i silent
Use the properties file in silent mode to execute a specific property. Type -f
fms_silent_install.properties.
The installer loads the properties file specified.
Note The installer uses the properties automatically when the filename and installer prefix are the
same. For example, vFoglight-5_2_4-install_windows-ia32.exe picks up vFoglight-5_2_4-
install_windows-ia32.properties automatically.
Property Description Default
INSTALLER_UI The property is set
to SILENT for silent
mode.
This is the default
setting and is
mandatory.
SILENT