Install Guide

21 Best Practices for Sharing an iSCSI SAN Infrastructure with Dell PS Series and SC Series Storage using VMware vSphere
Hosts | 2015-A-BP-INF
Note: At the time of this writing, the local vSphere host GUI, the new web-based utility that has replaced the
C-Sharp client, does not have the ability to set the secondary vmnic to unused for the kernel port group. This
can be accomplished either using the vCenter Web GUI, or a command line utility.
8. Repeat steps 6-7 for the second VMKernel port group (iSCSI-02).
Or, the command to execute at the command line to complete this task is:
[root@ESXi-Intel-PS:~] esxcli network vswitch standard portgroup policy
failover/ set –p portgroupname –a vmnic-to-be-active
Note: Be sure to execute this command for each VMKernel port group being used, as shown below.
9. Select Storage, Adapters, and click Configure iSCSI.