Install Guide

46 Citrix XenServer with Dell SC Series Storage Configuration and Deployment | 3132-CD-V
7 Create new Storage Repository (SR)
Once the volumes are mapped to the servers, they can be added to the XenServer using XenCenter or the
CLI. The following steps detail adding storage using XenCenter. The steps for adding storage through the CLI
can be found in the Citrix XenServer 7.0 Administrator’s Guide available on the Citrix Product Documentation
website.
7.1 Software iSCSI SRs
7.1.1 Identify SC Series storage iSCSI targets
To gather SC Series storage iSCSI target information: Within Dell Storage Manager, go to the Storage
tab, navigate to Fault Domains, and highlight iSCSI. This should display the target IPv4 addresses of the
control ports; one for each fault domain. The target addresses should be on the same IP subnet as the
server’s storage NICs. Figure 8 shows a multipath-dual subnet example, where Figure 9 shows a single
subnet bonded example.
Multipath – Dual Subnets: Identifying control port IP addresses
In the multipath – Dual subnet example, the IP addresses are:
 10.10.10.100/24
 10.20.10.100/24
Mutlipath – Single Subnet (Bonded NIC): Identifying control port IP address
In the multipath – Single subnet using Bonded NICs example, the IP address is:
 10.10.10.100/24
 10.10.10.110/24