Users Guide

32 Loading paper and original documents
Load up to Make sure that
25 sheets of photo/glossy paper
• The printable or glossy side of the paper is loaded faceup.
If you are not sure which side is printable, then see the
instructions that came with the paper.
• The paper guides rest against the edges of the paper.
• You do not touch or scratch the glossy surface of the
unprinted paper to prevent smudges or marks that may
affect the quality of your prints.
Notes:
– For best results, allow photos to dry at least 24 hours
before stacking, displaying, or storing.
– Draft mode is available but is not recommended for use
with expensive paper such as heavyweight matte,
labels, photo cards, and glossy paper.
10 iron‑on transfers
• You follow the loading instructions on the iron‑on transfer
packaging.
• The printable side of the transfer is faceup.
• The paper guides rest against the edges of the transfer.
Note: For best results, load transfers one at a time.
50 transparencies
• The rough side of the transparencies is faceup.
• The paper guides rest against the edges of the
transparencies.
• You remove any paper backing sheets from the
transparencies before loading.
• You load A4- or letter-size transparencies.
• If the transparencies have a removable strip, then each
strip faces up.
Note: Transparencies require more drying time. Remove
each transparency as it exits, and allow it to dry before
stacking or storing to avoid ink smudging.
.
Saving paper settings
You can adjust the settings for your print and copy jobs to match the paper size and type you have loaded in the printer.
1 From the printer control panel, press
2 Adjust the settings as needed:
• If you want to set the paper size, then navigate to:
Setup >
> Paper Setup > > Paper Size > > select the default paper size >
• If you want to set the paper type, then navigate to:
Setup > > Paper Setup >
> Paper Type > > select the default paper type >