Release Notes

SCSI BP firmware BP
SAS BP, SEP firmware BP
Storage enclosure PowerVault MD1000,
PowerVault MD1120, PowerVault MD1200,
PowerVault MD1220, PowerVault MD1400,
PowerVault MD1420
Tape drives firmware PowerVault 100T DDS4,
PowerVault 110T DAT72,
PowerVault 110T LTO1,
PowerVault 110T LTO2,
PowerVault 110T LTO2-L,
PowerVault 110T LTO3,
PowerVault 110T LTO3-HH,
PowerVault 110T LTO4,
PowerVault 110T SDLT320,
PowerVault 110T DLT VS80,
PowerVault 110T DLT VS160,
PowerVault 110T SDLT
Removable disk drive PowerVault RD1000
backup firmware
Network adapter firmware Broadcom NetXtreme family of adapters
Broadcom NetXtreme II family of adapters
Intel PRO PCI-E Gigabit family of adapters
QLogic Network family of adapters
Emulex Network family of adapters
Mellanox-Alpha Centauri Network family of adapters
Mellanox Network Adapter Firmware
KNOWN ISSUES
For all Dell Update Packages
 On a Hyper-V virtual machine setup, while updating the Host OS components,
ensure that the Guest OS’s is not running.
 If you try to run the inventory for after the Broadcom Inventory Collector is run, then Mellanox Inventory
Collector fails. To resolve, run the Mellanox Inventory Collector prior to running the Broadcom Inventory
Collector or install Mellanox Ethernet drivers.
 Do not run other applications while executing Dell Update Packages.
 For firmware Dell Update Packages, an update package will not inventory the device if only a native non-Dell
driver is installed. Thus the firmware update packages will not upgrade a device with a native driver.
 If the following error is displayed, Error while loading shared libraries: libstdc++.so.5: cannot open shared
object file: No such file or directory", install the compatibility libraries from your Linux distribution. To install
the compatibility libraries, use the following command:
"rpm -ivh compat-libstdc++-33-3.2.3-47.3.i386.rpm"
SLES 10 and SLES 11 (all service packs) uses
"libstdc++-33-32bit-3.3.3-11.9.x86_64.rpm"
 If Update Packages stop abruptly due to a power outage or abnormal termination, perform the following steps:
1. Remove the lock file.
2. Type the following command to do so: "rm -f /var/lock/.spsetup"
3. Run the Update Package again.
 If you see the message, "This Update Package is not compatible with any of the devices detected
on your system", for a supported device, ensure that you have the latest Dell drivers for