Users Guide

Executing DUPs On Systems Running Windows
To run DUPs from the interactive graphical user interface (GUI), perform the following steps. This procedure applies to all Update
Packages.
1. Execute the DUP by double-clicking the filename from within Windows Explorer.
2. Read the update information displayed in the DUP window.
3. Check the DUP inventory report for Package version and installed versions of component.
4. Click Install to install the DUP.
5. Reboot the system, if necessary.
To execute DUPs from the command line interface (CLI), see Command Line Interface Reference.
Verifying the Digital Signature On Systems Running
Windows
To verify the Update Package’s digital signature:
1. Start Windows Explorer and locate the Update Package whose digital signature you want to verify.
2. Right-click the filename.
3. Click Properties in the pop-up menu.
4. In the Properties window, click the Digital Signatures tab. If this tab is not displayed, the Update Package is not signed.
5. Select the signature from the signature list, and click Details.
The Digital Signature Details window appears.
NOTE: The signature is not verified until you click Details.
6. Read the digital signature information to verify that the digital signature is OK.
7. Click OK to close the window.
Compatibility checking
DUPs are designed to confirm that all prerequisites are satisfied before applying the update to the system. Each DUP checks to ensure
the following:
• The logged-on user has root privileges.
• DUP to be applied in the command is compatible with the target system and the operating system running on a system.
• The device associated with the DUP is present on the system.
• The minimum required versions of related system software are running on the system.
DUPs are designed with built-in error handling capabilities to ensure that the preceding requirements are validated. If the conditions are
not met, no update occurs. DUPs also check for dependencies between BIOS and certain ESM packages. The application design allows
you to create groups of DUPs and apply them to a wide range of systems. Additionally, if you only want to verify that a given package can
be applied to the system, you can invoke the package by using the following CLI command:
./Packagename.bin ‑c for Linux
packagename.exe /c /s for Windows
This command executes the dependency rules within the DUP, issues any warnings, exits without applying the update to the system, and
writes the results to the console. You can also use the DUP to set an exit code to perform decisions within the scripts.
Information while applying the Updates on a
Running System
This section describes all the effects of applying the updates on a running system.
12
Using Dell Update Packages