Users Guide

Setting Up the Monitor  │  33
Connecting the HDMI cable
NOTE: The default out of factory setting in the UP2720Q is HDMI 2.0. If
the monitor fails to show any content after the HDMI cable is
connected, follow the procedures below to change the settings from
HDMI 2.0 to HDMI 1.4:
• Press second button next to the button to activate the OSD menu.
• Use the and buttons to highlight Input Source, then use the
button enter the submenu.
• Use the and buttons to highlight HDMI.
• Press and hold the button for approximately 10 seconds, and the
HDMI configuration message appears.
• Use the button to select Disable and change the settings.
Repeat the above steps to change the HDMI format settings if necessary.