User`s guide
Table Of Contents
- Install the iSCSI Initiator Software (iSCSI-attached Host Servers Only)
- Perform Target Discovery from the iSCSI Initiator
- Configure CHAP Authentication on the Host Server (optional)
- Connect to the TL2000/TL4000 from the Host Server
- Guidelines for Configuring Your Network for iSCSI
- Reference information
Page
14
6) Re-configure your iSCSI initiator
7) Re-configure you ISV
Note: To delete the targets in Linux use the command below:
iscsiadm --mode node –T iqn.1988-11.com.dell.2000eb:eui.5000e11116c35003.0 --op=delete
iscsiadm --mode node –T iqn.1988-11.com.dell.2000eb:eui.5000e11116c35003.1 --op=delete