switch user guide TL2000

4. Using the Torx wrench included in your shipment, remove the screws (
1
) as
shown in Figure 4-10. Screw locations on the 4U library are similar.
5. Install the library rack anchors (2) as shown in Figure 4-11 on each side of
your library using the longer counter-sunk screws included in the rack kit.
6. Install the library mounting brackets (1) as shown on the 2U library on each
side of the library using the screw that was removed from your library and an
a77ug196
Figure 4-9. Front view of a rack showing the rails installed
a77ug189
1
Figure 4-10. 2U library side screws to remove
a77ug188
1
2
Figure 4-11. 2U library rack anchors and mounting brackets
Chapter 4. Installation and Configuration 4-9