Administrator Guide
20 | System Settings
Position
Left of or Right of -If your monitors are positioned in a side-by-side
arrangement, then you'll want to specify one of the monitors as being to
the Left of or Right of the opposite monitor.
Above or Below-If your monitors are positioned in a top and bottom
arrangement, then you'll want to specify one of the monitors as being to
the Above or Below the opposite monitor.
Clone-Choosing the Clone option will cause the display to be duplicated
on both monitors. (Also known as “Mirrored.”)
NOTE:
This is the default behavior for dual monitors when powered on for the
first time.
Offset-When you select the offset option, you will be presented with two
additional fields for X and Y coordinates. For example: 50x50 will
cause the display to be positioned 50 pixels left of and 50 pixels higher
than its normal centered state.
Rotation-
Select
Right
to rotate the display clockwise and
Left
to rotate
the screen counter-clockwise. You can also select
Invert
to flip the entire
display upside down.
Reflection-
Select
X
,
Y
, or
XY
values to rotate the screen along the XY
plane.
NOTE:
The X plane is Horizontal. The Y plane is Vertical.
Once you are finished, press the
Apply
button and reboot the thin client for the
changes to take effect.
Input/Time
This section allows you to configure keyboard, mouse, and time settings for the
terminal.
1
From the DeTOS Desktop, select
DeTOS
Control Panel
.
2
Select the
Input/Time
icon on the left-hand side of the
Control Panel
under
System
.