Owner`s manual
Table Of Contents
- Dell Precision Tower 7910 Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- System Overview
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit (PSU)
- Removing the Front Cover
- Installing the Front Cover
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Left Cover
- Installing the Left Cover
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the PCI Card
- Installing the PCI Card
- Removing the Slimline Optical Drive
- Installing the Slimline Optical Drive
- Removing the Memory Shroud
- Installing the Memory Shroud
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink
- Installing the Heatsink
- Removing the Liquid Cooler Heatsink (Optional)
- Installing the Liquid Cooler Heatsink (Optional)
- Removing the HeatSink Fan
- Installing the Heatsink Fan
- Removing the PCIe Card Retention
- Installing the PCIe card retention
- Removing the System-Fan Assembly
- Installing the System-Fan Assembly
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the I/O Panel and the USB 3.0 Ports
- Installing the I/O Panel and the USB 3.0 Ports
- Removing the Power Switch
- Installing the Power Switch
- Removing the Speaker
- Installing the Speaker
- Removing the Right Cover
- Installing the Right Cover
- Removing the 5.25-inch Optical Drive
- Installing the 5.25-inch Optical Drive
- Removing the HDD Thermal Sensor
- Installing the HDD Thermal Sensor
- Removing the Processor
- Installing the Processor
- Removing the Hard-Drive Fan
- Installing the Hard-Drive Fan
- Removing the Power Supply Unit (PSU) Card
- Installing the Power Supply Unit (PSU) Card
- System Board Components
- Removing the System Board
- Installing the System Board
- Additional Information
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Technical Specifications
- Contacting Dell
Installing the Slimline Optical Drive
1. Slide the optical drive into its compartment and ensure it is seated firmly.
2. Connect the power cable and the data cable to the back of the optical drive.
3. Install the left cover.
4. Follow the procedures in After Working Inside Your Computer.
Removing the Memory Shroud
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. left cover
b. optical drive
3. Press down on the blue retaining tabs on each side of the memory shroud and lift the memory
shroud upwards.
4. Press down on the release latch on the other side of the memory shroud module to release it from
the chassis.
23