White Papers

19
Output:
Job ID = JID_123456789012
RAC1154: The requested operation is initiated.
Run the RACADM jobqueue sub-command, using the job id to check the status of the requested operation.
racadm supportassist exportlastcollection
To export an existing SupportAssist Collection to a specific network share or to a default network share (See Setting Default
Network) .
 To export an existing collection to the default network share (See Setting Default Network), use the following command:
racadm supportassist exportlastcollection
 To export an existing collection to a specific CIFS share other than the default network share, use the following command:
racadm supportassist exportlastcollection -l //192.168.10.24/share -u username -p passwd
 To export an existing collection to a specific NFS share other than the default network share, use the following command:
racadm supportassist exportlastcollection –l 10.94.161.103:/supportassist_share
Output:
Job ID = JID_123456789012
RAC1154: The requested operation is initiated.
Run the RACADM jobqueue sub-command, using the job id to check the status of the requested operation.
racadm supportassist uploadlastcollection
To export an existing SupportAssist Collection to Dell EMC (on registered servers), use the supportassist uploadlastcollection
command.
Note: For information on registering for SupportAssist, see the SupportAssist on Dell EMC’s 14th generation of PowerEdge servers
technical white paper.
Output:
Job ID = JID_123456789012
RAC1154: The requested operation is initiated.
Run the RACADM jobqueue sub-command, using the job id to check the status of the requested operation.
Job status
To check the status of a job, use the following command:
racadm jobqueue view –i JID_123456789012
[Job ID=JID_123456789012]
Job Name=SupportAssist Collection
Status=Completed
Start Time=[Not Applicable]
Expiration Time=[Not Applicable]
Message=[SRV088: The SupportAssist Collection and Transmission Operation is completed successfully.]
Percent Complete=[100]