Administrator Guide

ManualsBrandsDell ManualsConverged InfrastructureSystems Management Solution Resources

Technical support and resources

9 Telemetry Streaming with iDRAC9 – Storage Reports | ID 430

NumOfErrorInfoLogEntriesUpper

Contains the upper part of the count of error

information log entries over the life of the

controller

PercentageUsed

Specifies a vendor specific estimate of the

percentage of NVM (Non Volatile Memory)

subsystem life used based on the actual usage

and the manufacturer's prediction of NVM life

PowerCyclesLower

Specifies the lower part of the number of power

cycles

PowerCyclesUpper

Specifies the upper part of the number of power

cycles

PowerOnHoursLower

Specifies the lower part of the number of hours

powered on. Hours may not include time that the

controller was powered and in a non-operational

power state

PowerOnHoursUpper

Specifies the upper part of the number of hours

powered on. Hours may not include time that the

controller was powered and in a non-operational

power state

UnsafeShutdownsLower

Contains the lower part of the number of unsafe

shutdowns. This count is incremented when a

shutdown notification (CC.SHN) is not received

prior to loss of power

UnsafeShutdownsUpper

Contains the upper part of the number of unsafe

shutdowns. This count is incremented when a

shutdown notification (CC.SHN) is not received

prior to loss of power

2.1.3 StorageSensor Metric Report

Metrics of the StorageSensor telemetry report and the corresponding description of the metrics:

StorageSensor

TemperatureReading

Temperature information for server storage

internal devices

2.2 Supported Devices for Storage Metric Reports

• StorageDiskSMARTData: SAS/SATA SSD drives behind PERC storage controller

• NVMeSMARTData: PCIeSSD/NVMe devices (drives and HHHL cards) not behind SWRAID controller

• StorageSensor: PCIeSSD/NVMe devices (drives and HHHL cards), SAS/SATA HDD/SSD drives

behind PERC, BOSS M.2 drives and SATA HDD / SSD behind SWRAID controller

2.3 Special Cases of Hot plug Storage Devices

When the drives get hot swap, all the three Storage reports will reflect the change on the fly within the report

Interval.