Reference Guide

185 Lifecycle Controller Web Services Interface Guide for Linux
The input file SetAttributes_Integer_RAID_Controller.xml is shown below:
<p:SetAttributes_INPUT
xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cimschema/2/root/dcim/DCIM_RAIDS
ervice">
<p:Target>RAID.Integrated.1-1</p:Target>
<p:AttributeName>RAIDccRate</p:AttributeName>
<p:AttributeValue>60</p:AttributeValue>
<p:AttributeName>RAIDreconstructRate</p:AttributeName>
<p:AttributeValue>60</p:AttributeValue>
<p:AttributeName>RAIDbgiRate</p:AttributeName>
<p:AttributeValue>60</p:AttributeValue>
</p:SetAttributes_INPUT>
OUTPUT:
<n1:SetAttributes_OUTPUT>
<n1:Message>The method was successful.</n1:Message>
<n1:MessageID>STOR001</n1:MessageID>
<n1:RebootRequired>Yes</n1:RebootRequired>
<n1:ReturnValue>0</n1:ReturnValue>
<n1:SetResult>Set Pending Value</n1:SetResult>
</n1:SetAttributes_OUTPUT>
16.23 Convert Physical Disk Drives to RAID-ConvertToRAID()
The ConvertToRAID() method is used to convert physical disk drives in Non-RAID state to a state usable
for RAID. After the method is successfully ran the PendingValue property of RAIDPDState should reflect
the pending changes. After the CreateTargetedConfigJob() method is successfully ran the RAIDStatus
property, which is enumerated in the DCIM_PhysicalDiskView from Section 16.9, of that physical disk
drive should reflect the new state.
Invoke ConvertToRAID() with the following parameters and syntax:
Physical Disk TARGET: Obtained from the FQDD field (Section 16.9)
An example of Disk.Bay.2:Enclosure.Internal.0-0:RAID.Slot.1-1 is shown below.
EXAMPLE:
winrm invoke ConvertToRAID
"cimv2/root/dcim/DCIM_RAIDService?SystemCreationClassName=DCIM_ComputerSystem
+CreationClassName=DCIM_RAIDService+SystemName=DCIM:ComputerSystem+Name=DCIM:R
AIDService"
-h $IPADDRESS -V -v -c dummy.cert -P 443
-u $USERNAME -p $PASSWORD
-J СonvertToRAID.xml -j utf-8 -y basic
The input file ConvertToRAID.xml is shown below:
<p:ConvertToRAID_INPUT
xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cimschema/2/root/dcim/DCIM_RAIDS
ervice">
<p:PDArray>Disk.Bay.2:Enclosure.Internal.0-0:RAID.Slot.1-1</p:PDArray>
</p:ConvertToRAID_INPUT>
OUTPUT:
ConvertToRAID_OUTPUT
RebootRequired = 1
ReturnValue = 0