Owner's Manual

configuration has changed. Accepting these changes on the command line may not be enough, enter the
firmware utility and reset the controller.
Issue 9
Description: On CERC ATA or CERC SATA RAID controller cards, disks that appear in "Legacy" mode are not
available for RAID configuration in SBUU. To use any disk that is in "Legacy" mode as part of a RAID
container, you must use the RAID controller firmware utility to initialize these disks. Similarly, if all disks are
in "Legacy" mode, then SBUU may fail to configure RAID on the controller.
Issue 10
Description: The Server Setup program may fail if it runs when scrubbing is active on a RAID virtual disk.
Issue 11
Description: SBUU does not identify the boot device when PERC 4DC controller is in cluster mode and the
adapter's BIOS is disabled. This puts SBUU in an infinite "Write Disk signature" and reboot loop. Use SBUU
to install the operating system on PERC in a non-cluster mode.
Issue 12
Description: SBUU cannot detect the correct slot number of PCI slots containing Adaptec RAID controllers.
The message, "Unknown Slot Number" appears.
Issue 13
Description: On systems with low memory (less than 256 MB) and more than one RAID controller, SBUU
may fail during RAID configuration. Install the additional adapters after the operating system has been
installed on the first adapter.
Issue 14
Description: When using the Custom install script feature, commands which do not return cause the
system to stop responding during booting of Red Hat Enterprise Linux or while registering components on
Windows installations.
Issue 15
Description: On DELL PERC/SAS RAID controller cards, disks that appear in "Foreign" state are not available
for OS installation in non-RAID mode. If all disks are in "Foreign" state, SBUU may fail to install OS on the
controller in non-RAID mode.
Issue 16
Description: When you use SBUU with a keyboard-video-monitor (KVM) switch, the GUI may not display
owing to incompatibility with the Server Interface PODs (SIPs) used. To view the GUI, connect your monitor
directly to your system or change the SIP.