Owner's Manual

file:///T|/htdocs/SOFTWARE/smsbu/1_5/EN/readme/readme.txt[10/23/2012 1:02:13 PM]
Administrator Compatibility Guide" and the "Dell Systems Software
Support Matrix."
* On a system with Embedded SD card slot, if ESXi Installer and recovery OS is
supported, it is shown in the operating system list for all controllers,
independant of whether the SD card is enabled or disabled in the BIOS.
======================================================================
USER NOTES ON Dell Utility Parition installation
======================================================================
Utility Partition will not be created if the system on which you are trying to
install does not support a Utility Partition.
######################################################################
KNOWN ISSUES
######################################################################
The following subsections list the known issues with this release of
Systems Build and Update Utility.
* Do not export configuration files from PE to SC servers and
vice-versa since this is not supported.
* On Dell PowerEdge systems with internal USB, BIOS setting
configuration for internal USB Port is possible only if User
Accessible/external (UA) USB ports are set to "All Ports On".
If UA USB ports are not set to "All Ports On" and user tries to
configure BIOS setting for internal USB Port using Server
Administrator GUI or CLI, the configuration will appear to be
successful but the changes will not take effect on next reboot.
If UA USB ports settings are changed from "All Ports On" to "All
Ports Off" or "Only Back Ports On", the USB will be automatically
set to "Off" during the next reboot.
* System Build and Update Utility (SBUU) will not boot through DVD under
BIOS in UEFI mode.
* If you return to a page (including Home Page) directly from the operating
system installation page, it may take some time for the new page to load.
======================================================================
KNOWN ISSUES ACROSS ALL OPERATING SYSTEMS
======================================================================
* Systems Build and Update Utility does not support RAID
configuration on any system with a SAS 5/iR or SAS 6/iR controller
connected to one hard drive. To install Systems Build and Update
Utility on a system with the SAS 5/iR or SAS 6/iR controller, ensure
at least two hard drives are connected.
* Systems Build and Update Utility does not support RAID
Configuration on any system with a SATA 2S controller connected to
one hard drive. To install Systems Build and Update Utility on a
system with the SATA 2S controller, set the hard drive configuration