Owner's Manual

file:///T|/htdocs/SOFTWARE/smsbu/1_3/en/readme/readme.txt[10/23/2012 1:07:18 PM]
which is not supported in the current system, applying Hardware
Scripts will fail and if Exit on Failure option is selected, the
deploy operation will halt.
* When the User selects the Redundant Memory token in the BIOS page
in Hardware Config screen, the options shown for this token are a
superset. If the user selects an option which is not supported in the
current system, the apply operation will fail during execution and
the option will not be applied on the box.
* When the User selects to use Operating System ISO's from network
location and during copy operation, if the network is disconnected
for a while and then reconnected, in case of NFS shares, it will
resume the copy operation but, in case of SMB/Windows share, it will
not resume the copy operation. Disconnection on a SMB/Windows share
will result in an error and user has to reboot and re-run the
operation.
* The values configured in the multi-sys-config.csv file will be
applied only during execution. Only those options are applied that
are shown during configuration time. However, options that are not
shown during configuration, but are part of multi-sys-config.csv file
will be ignored. Note: If there is any overlap in the settings
between Configuration GUI and multi-sys-config.csv file, then
settings in multi-sys-config.csv file will override those made in
the GUI.
* The installation times for different versions of the Windows Server
2008 operating system will vary considerably. This is because of the
differences in the software and drivers utilized in different
versions of the Windows Server 2008 operating systems and the
capabilities of the installation platform. On the "Installing
Windows" screen, the "Completing installation" step, where the
drivers are installed, may take considerable time to complete.
* If you configure the BIOS or iDRAC6 entry with "Setup Password
Override" checkbox under "Power" Section and then you Export the
configurations and then import the same configuration and view/Edit
the imported configuration.
User will see the 'Setup Password Override' checkbox is not checked.
======================================================================
USER NOTES FOR WINDOWS OPERATING SYSTEMS
======================================================================
* If you are using the SBUU iso image downloaded from the support site
at support.dell.com and installing Microsoft Windows 2008, download
Windows OS Install Support Pack package from the support site.
Create your own optical media from the Windows OS Install Support Pack
package and make it available to SBUU when prompted.
* During Windows installation, the system will automatically log on
to finish the post-installation tasks and will then automatically log
out. It is recommended that you do not perform any task until the