Owner's Manual

file:///T|/htdocs/SOFTWARE/smsbu/1_2/en/readme/readme.txt[10/23/2012 1:18:45 PM]
* Obtain the ISO image file of the media from known sources.
* Try burning the media at slower speeds
* Use the "Disk at Once" or a similar option.
* Close the session.
======================================================================
USER NOTES FOR VMware ESX
======================================================================
* ESX 3.0.2 Update 1 or later versions support following systems
and devices:
- Intel Xeon E5400/L5400/X5400, and E7300/L7300/X7300 processor
families
- Dell PERC 6 and SAS 6 family SAS controllers
- SATA Optical Drives
For details on the hardware support and ESX build number, see
"www.dell.com/vmware" on the Dell Support website at
"support.dell.com." Also, see the "Dell OpenManage Server
Administrator Compatibility Guide" and the "Dell Systems Software
Support Matrix."
######################################################################
KNOWN ISSUES
######################################################################
The following subsections list the known issues with this release of
Systems Build and Update Utility.
* On Dell PowerEdge systems with internal USB, BIOS setting
configuration for internal USB Port is possible only if User
Accessible/external (UA) USB ports are set to "All Ports On".
If UA USB ports are not set to "All Ports On" and user tries to
configure BIOS setting for internal USB Port using Server
Administrator GUI or CLI, the configuration will appear to be
successful but the changes will not take effect on next reboot.
If UA USB ports settings are changed from "All Ports On" to "All
Ports Off" or "Only Back Ports On", the USB will be automatically
set to "Off" during the next reboot.
======================================================================
KNOWN ISSUES ACROSS ALL OPERATING SYSTEMS
======================================================================
* Systems Build and Update Utility does not support RAID
configuration on any system with a SAS 5/iR or SAS 6/iR controller
connected to one hard drive. To install Systems Build and Update