Owner's Manual

file:///T|/htdocs/SOFTWARE/smsbu/1_0_7/en/readme/readme.txt[10/26/2012 2:42:30 PM]
* Do not insert or remove any hot-swappable drives until the
operating system is completely installed while using the
"Systems Build and Update Utility". The results may be
unpredictable and the installation may fail.
* Use local accounts for creating the Server Message Block (SMB)
share on Windows on which the RPMs will reside for the network
download feature.
* Systems Build and Update Utility does not support the
installation of tape or Fibre Channel drivers with the operating
system installation. You can download the drivers for these
devices from the Dell Systems Service and Diagnostics Tools on
the "Dell Systems Management Tools and Documentation" DVD
or from the Dell Support website at "support.dell.com."
* The "Keyboard Type" locale option offered for a keyboard layout
on the Systems Build And Update Utility Home page is to
navigate the Systems Build and Update Utility navigation
only. The selected keyboard layout setting is not passed to
the installed operating system.
Even after you select any language other than English under
"Select Language" and "Keyboard Type" on the "Home" page,
the input language will be English. That is, the text
you enter in the text fields in the GUI will appear in English.
* The Utility Partition created by Systems Build and Update Utility
contains diagnostic utilities for your system. On rare occasions,
incompatibilities between disk firmware and controller firmware
may cause the Utility Partition to be inaccessible. In this case,
you can download the diagnostic utilities for your system from
the Dell Support website at "support.dell.com" to some other
media and perform the system diagnostics by booting from that
media.
* Do not use the Dell Remote Access Controller (DRAC) virtual
media to run "Firmware Update" on the system. This procedure
breaks the virtual media connection, causing the firmware
update procedure to fail.
* USB keys formatted with NT File System (NTFS) or file
allocation table (FAT) are not supported.
* Any network or Windows share or CD/DVD that you use an input
to the Repository must not contain any extra file or folder that
is not part of the Server Update Utility (SUU) content.
* When you select the "No Change" option for Trusted Platform
Module (TPM) Activation, under Boot sequence and security tab,
the TPM activation token will not be saved to the ".ini" file.
* "Digitally sign communications" enabled Windows share on a
system running on Windows cannot be accessed. To access the