Owner's Manual

file:///T|/htdocs/SOFTWARE/smsbu/1_0_3/en/readme/readme.txt[10/26/2012 2:43:53 PM]

system is not supported on any system having the following

controllers:

- CERC ATA 4-CH

NOTE: In the above case, the option to install Red Hat Enterprise

Linux (version 4) is unavailable in the

"Select Operating Systems" page.

* Installation of Red Hat Enterprise Linux (all versions) operating

system is not supported on any system having the following

controllers:

- Promise RAID

- CERC SATA 2S in RAID mode

NOTE: In the above cases, option to install Red Hat Enterprise

Linux operating system will not be presented in the "Select

Operating Systems" page.

======================================================================

KNOWN ISSUES FOR SUSE (R) LINUX ENTERPRISE SERVER (VERSIONS

9 AND 10) OPERATING SYSTEMS

======================================================================

* SUSE Linux Enterprise Server (versions 9 and/or 10) operating

system may fail to install on systems equipped with multiple

RAID and/or SCSI controllers, whether installed on the system

board or in PCI slots. This failure may occur when using

"Server Setup" or performing a manual installation. When two or

more RAID or SCSI controllers are present, install SUSE Linux

Enterprise Server (versions 9 and/or 10) with only one configured

RAID or SCSI controller. Configure the other controllers after you

install the Novell SUSE Linux Enterprise Server

(versions 9 and/or 10) operating system.

* The SUSE Linux Enterprise Server (version 9) operating system

installation may fail on systems equipped with multiple disks and

the boot device is set to a disk that does not have the lowest

port number. To ensure successful installation across all

supported operating systems, it is recommended that the boot

device is set to the disk with the lowest port number.

* SATA optical devices are not supported with the SUSE Linux

Enterprise Server version 9, SP3 operating system. Systems Build

and Update Utility can install SUSE Linux Enterprise

Server version 9, SP3 using the SATA optical drive. However,

if you try to use the SATA optical drive after installation,

the drive will not be detected by the operating system.

######################################################################

Information in this document is subject to change without notice.