User's Manual

For information about report filtering, see Report Filtering.

Report Filtering

During Dell System E–Support Tool (DSET) report collection, you can filter a few data from the report such as:

• Host name

• IP address

• Subnet mask

• Default gateway

• MAC address

• DHCP server

• DNS server

• Processes

• Environment variables

• Registry

• Logs

• iSCSI data

• Fibre Channel data (host WWN and port WWN)

NOTE: For one-time report collection (Zero FootPrint report), all of the above data is filtered. In permanent

installation, you can specify the data to be filtered.

To enable the data filtering, select the Enable Report Filtering option during report collection. For information on Report

Filtering, see “Installing, Upgrading, and Running DSET Application On Windows Operating System” or “Installing,

Upgrading, And Running DSET Application On Linux Operating System” section in the

Dell System E-Support Tool (DSET)

Version 3.x Installation Guide

available at dell.com/serviceabilitytools.

To include any of the data to the report, specify ’no’ in the following file:

• On systems running Windows — <system drive>:\Program Files (x86)\Dell\AdvDiags\DSET\config\

privacy_presetlist.cfg (in 64-bit systems) or <system drive>:\Program Files\Dell\AdvDiags\DSET\config

\privacy_presetlist.cfg (in 32- bit systems).

• On systems running Linux — /opt/dell/advdiags/dset/config/privacy_presetlist.cfg

NOTE: The data is not filtered from the file logs collected in the report. The logs may contain data such as IP or

MAC address and so on. If logs are set to "no", then the data is not filtered in the report.

CLI Options

This section provides the CLI options for systems running Windows and Linux.

On Systems Running Windows

To start the CLI mode, in the Start menu, navigate to DSET 3.5 → DSET CLI. The CLI command window opens and

displays the location of the installed support files as:

<InstallDirectory>\AdvDiags\DSET\bin

NOTE: If you are using a system running the 64-bit Windows operating system, the CLI command window displays

the location of the installed support files as:

<InstallDirectory>\Dell\AdvDiags\DSET\bin