Quick Start Manual

• DSET and Remote Provider

• DSET

• Remote Provider

NOTE: You must be logged in as root to install DSET application.

1. At the Linux shell prompt, run the ./dell-dset-lx(bit)-(Version Number).bin file.

The License Agreement is displayed along with the following message:

Do you agree to the above license terms? ('y' for yes | 'Enter' to exit):

2. Enter y.

The installation types are displayed. The following table provides the installation types:

Table 4. :Installation Types

Type Installation Option Description

1 Install/Upgrade DSET and Remote Provider

(Recommended)

Select this option to permanently install DSET

and Remote Provider to generate reports for

local and remote systems and also remote

report collection from this system.

2 DSET Select this option to permanently install the

required components to generate report from

remote systems.

3 Remote Provider Select this option to permanently install the

required components to allow reports to be

generated from a remote system against this

system.

NOTE:

– For DSET application version 2.2 or lower, installation type 1 is displayed.

– If version 3.2 or later of 'DSET and Remote Provider', or 'DSET', or 'Remote Provider' is currently

installed in the system, then installation types 1, 2, and 3 are displayed.

– For DSET application 3.5:

* If DSET is currently installed in the system, then installation type 3 is displayed.

* If Remote Provider is currently installed in the system, then installation type 2 is displayed.

3. Enter the <option number> to select the required installation type.

If Install/Upgrade DSET and Remote Provider or Remote Provider option is selected, then

during installation if SFCB or OpenPegasus is not installed or running, the following message is displayed:

The Small Footprint CIM Broker (SFCB) is a network service that enables

remote collection of system configuration information.

To perform the option that you selected, it is necessary to install and

start this service and leave it running in background for future

configuration collection.

Continue installing/activating the SFCB on this system to listen for

incoming collection requests from clients. Do you want proceed[y|n]?

4. Enter y.

If OpenPegasus is installed and running, the following message is displayed:

DSET collects the Hardware data via Common Information Model Object

Model(CIMOM): tog-pegasus, which is already present on this system, Please

enter the Administrator/Root password to validate the existing tog-pegasus