Quick Start Manual

• Dell_DSET_(version number).exe ADDLOCAL=<full/collector/provider>

INSTALLDIR=<location> /qn — This performs silent installation that does not display any graphical

progress bar.

NOTE:

• ADDLOCAL parameter in the command is optional.

• For version 3.2 and later, while upgrading, if ADDLOCAL parameter is not included in the command, then

only the installed component is upgraded.

• For version 2.2 or lower, if Dell_DSET_(version number).exe /qn is run, then both DSET

application is upgraded.

Where:

full = Full installation of both DSET and Remote Provider on the local system.

collector = Installation of DSET only for remote collection.

provider = Installation of Remote Provider only for remote collection from a remote system.

If DSET application version 3.2 or later is currently installed in the system, use the following options to upgrade to

version 3.4:

Table 1. : Upgrading scenarios from DSET application version 3.2 or later to version 3.4

DSET and Remote Provider DSET Remote Provider

DSET and Remote Provider Yes Yes Yes

DSET Yes Yes Yes

Remote Provider Yes Yes Yes